Ready for Spring? - Fly Fishing Forum
Propwash A boat is a hole in the water into which you pour... good times!

Reply
 
Thread Tools Search this Thread Rate Thread Display Modes
  #1  
Old 03-27-2003, 11:53 PM
Slinger's Avatar
Slinger Slinger is offline
CantAnchorUs
 
Join Date: Jan 2002
Location: Rhode Island
Posts: 733
Ready for Spring?

This being the first spring that I`ve had a boat, could someone give me a brief rundown of what`s required to get it ready for the water? It`s only a 16` tin with a 40 horse Evinrude, I pulled the batteries and fogged the motor last fall. Is it a major undertaking?
Slinger
__________________
Steve
Reply With Quote Quick reply to this message
  #2  
Old 03-28-2003, 07:20 AM
bcasey's Avatar
bcasey bcasey is offline
Registered User
 
Join Date: Mar 2001
Posts: 517
Steve,
Most of the year end and spring maintenance on my boat is done by the shop where I bought it, so I don't have alot of experiance with it. Some of the recent publications, On the Water, The Fisherman..., have a section around this time of year dedicated to spring start-up as well as trailor maintence, I'll look thru some recent ones and see what I can find.
__________________
CASE
Reply With Quote Quick reply to this message
  #3  
Old 03-28-2003, 11:21 AM
steelheadmike steelheadmike is offline
Registered User
 
Join Date: Feb 2002
Location: Hudson River, Croton River, Salmon River, CT,RI,MA
Posts: 607
Slinger

You should be all ready to go. If the engine was winterized all you need to do is squeeze the fuel ball, choke it and go. Just let it warm up for 5-10 minutes if the water is cold.
Reply With Quote Quick reply to this message
  #4  
Old 03-28-2003, 09:27 PM
JimW JimW is offline
Registered User
 
Join Date: Feb 2000
Location: As long as it's Salty
Posts: 1,795
Slinger,
This is my first Spring thaw too. I don't know much but I'll offer some advice I've picked up here and there. Use new gas - if you did not use fuel stabilizer in the Fall it might be best not to use the old gas in your engine. Others please comment on this. What's the shelf life on gasoline mixed with 2-cycle oil?
The shop where I got my supplies recommended using a carbon remover (basically an overpriced can of Gumout) after starting the engine and running it for a while you use the carbon remover to clean out all the burnt up fogging oil. They said to give it another treatment 1/2 way through the season, something about it being cheaper than a new power head. :eyecrazy: New plugs might be a good idea. Changing the fluid in the lower unit might not be a bad idea. Here's to no water in your gear oil.... Don't forget the trailer wheel bearings.

Last but not least - make sure the water is on when you run the engine. :
Reply With Quote Quick reply to this message
  #5  
Old 03-29-2003, 12:07 PM
jfbasser's Avatar
jfbasser jfbasser is offline
Pencil me in.....
 
Join Date: Aug 2002
Location: The Nearside of the Middleside
Posts: 1,070
About 12 years ago carbon buildup was causing engine failure. To combat this manufacturers tried to suspend carbon cleaner in oil to alleviate the problem. They were unsuccessful, but to avoid having to ask all those people with oil injection to put an additive in the gas like they did with oil in the old days and inconvenience them they suggested using gasoline with injecter cleaner (Sunoco Ultra and a few others at the time) and to decarborize twice a year. Finally, TCW3 was formulated with the cleaner suspended and I was told that use of that oil was sufficient.
Reply With Quote Quick reply to this message
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
ARE YOU READY FOR SOME.... juro Worldwide Flyfishing Discussion 16 01-23-2006 01:51 AM
Are you ready... Stevo Stripers and Coastal Gamefish 16 01-22-2006 08:32 AM
Boat almost ready for Spring!! longrod Propwash 3 11-24-2003 08:04 PM
Ready to go Tod D the Rod Rack 4 02-19-2002 09:10 PM


All times are GMT -5. The time now is 08:14 AM.



Copyright Flyfishingforum.com (All Rights Reserved)