Fly Fishing Forum - View Single Post - Question on grinding guide feet...
View Single Post
  #2  
Old 05-02-2002, 07:46 AM
JimW JimW is offline
Registered User
 
Join Date: Feb 2000
Location: As long as it's Salty
Posts: 1,795
I had asked Smitty the same question. No sanding is required on the bottom of the feet. Make sure you don't leave any sharp edges or burrs. It is important that the guide feet lay flat against the blank, this is done by simply bending them. I think one of the advantages of buying the guides at Rod builders is they needed no adjustment. The mail order house guides needed some tuning.
Reply With Quote