Fly Fishing Forum

Fly Fishing Forum (
-   >> Archive: Salmon & Steelhead Flies (
-   -   The Boob Tube (

kush 02-18-2003 10:59 PM

The Boob Tube
Well, here it is... long rumoured and seldom seen - though I now hear Sinktip has a copy and one of the raffle boxes at the Bellvue Show contains a sample.

The Boob Tube evolved from a British trout pattern known as the Boobie. It was tied in relatively small sizes with a long marabou tail and fished with a 2-3' leader on a Hi-D sinking line for large trout in lakes. It was so deadly that it was banned from many British lakes. I tried it in the Kamloops lakes - it is deadly!

I then decided to adapt it as a steelhead waker. Tied on a Wilson hook it caught its first steehead less than 15 minutes into its maiden voyage on the Bulkley River. After I got into tube flies it struck me that it would be easy to adapt the concept to the tube.

There are two advantages to the Boob Tube, first it allows for a large hook gap - a problem with many deer hair wakers - solid hook-ups result. Secondly, I further enhanced the already considerable waking ability by using a trick from Europe to wake tubes - that is to pierce the underside of the plastic tube with a hot needle. I then use the hole to pass the leader into the tube from the bottom, then out throughthe rear of the tube to be tied to the short shank hook which is then set into the rear of the tube. The beauty of this is that the fly is cocked upward and will wake in absolutely any water conditions!

The recipe is very simple:

Tube - black truck air brake line (auto supply shop)

Boobs - foam sticks sold in flyshops - the same ones that are cut
lengthways to make Soveral's Foamers. Tie a short
piece across the top of the tube with figure 8 wraps
cinch it down hard and then cement. After it is dry
(I usually prepare 4 or 5 at a time) clip it into the familiar
and pleasing shape that gives the fly its name.

Wing - Deer hair, stacked and tied not to spin, but to flair (it is
same as an elk hair caddis - except ther are a couple of
foam boobs in front of it! trim the butts even with the
top of the boobs and cement it well.

I use a heated bodkin needle to form the hole. Start a ways back from the end of the tube and push it forward at a 45 degree angle. Tie it on heave it out there and watch the sucker wake!

kush 02-18-2003 11:06 PM

A 2nd Look at those boobs...
This shows the boobies a little better.

pmflyfisher 02-19-2003 05:48 AM


I like the new logo ? Admiral Jet Sled was a bit too intimidating to some. Have not seen the dreaded Jet Sled thread emerge yet this winter like last either.

Bet that Boobie floats like a veritable cork. I have seen the "Boobie" pattern in the english fly fishing magazines which I periodically pick up a the book store.


PM Out

sinktip 04-24-2003 11:33 AM

I must say they also look pretty good in purple. I fear I have caught the sickness that is going around. Only instead of intruders, I am producing boob after boob. Please July, get here soon!

kush 04-24-2003 11:40 AM


Yes, I picked up some purple deer hair the other day. Of course I got it for my Intruder addiction, but I will admit that I noted that there would be a few Purple Boobies in my fly box ( maybe they should be called "Purple Hermans"?).

metalhead 04-25-2003 12:31 AM

anatomy question
is it tied with or without let's say bumps?:eyecrazy:

striblue 04-25-2003 05:31 AM

I love the originallity of the names. Wish I could think of an east coast striper pattern with the "Big Wallys".

sinktip 04-25-2003 09:58 AM


That depends on how good one is with the scissors.

fredaevans 04-25-2003 11:18 AM

Kush has a first!
First "x-rated" post to the Board. Were do we go:tsk_tsk: from here?

JDJones 04-25-2003 01:23 PM

a riffle hitched tube fly
love it! Kush just keeps coming up with winners.:chuckle:

JDJones 09-05-2003 04:19 PM

boob tubes
I tied up some of these things and boy to they throw up a wake.
Only trouble I've had with them is, I guess do to my agggressive casting, I sometimes manage to do a macectomy on one side. And then it doesn't skate so well after that. Anyone else had that problem?


flytyer 09-05-2003 11:08 PM


The simple fix to the masectomy I found is to put a hitch behind the boobies but pull it tight on the bottom of the hook (if using low-water hooks like I do) causing the leader to come off the bottom of the fly. This actually enhances the waking of the fly.

JDJones 09-06-2003 01:42 AM

hitched boobies
I was doing this,,, kind of. I had burned a hole up through the bottom of the tube and was threading the leader through the hole in the bottom of the tube and out the back.


flytyer 09-06-2003 10:06 PM


That should work. Maybe burn the hole a little bit further back on the tube. You really want the leader to exit the fly behind the boobies.

JDJones 09-07-2003 11:46 AM

behind the boobies
If you burn the hole behind the boobies, you are burning through the thread wraps that hold the Elk hair. And since it is an extra step in the tying process and a bit of a bitch sometime to thread the leader in through the bottom, maybe a simpler solution would be just to thread the leader straight through the tube and then throw a couple of half hitches behind the boobies? I'll try that and report back.


All times are GMT -5. The time now is 11:51 AM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright (All Rights Reserved)