Fly Fishing Forum

Fly Fishing Forum (http://www.flyfishingforum.com/flytalk4/index.php)
-   Yak Attack (http://www.flyfishingforum.com/flytalk4/forumdisplay.php?f=39)
-   -   Form and function (http://www.flyfishingforum.com/flytalk4/showthread.php?t=28178)

desmobob 06-26-2010 11:07 AM

Form and function
 
When I was on the Cape earlier this month, I had the opportunity to do some kayaking/fishing with Penguin and Rooster. They both had the most beautiful and effective anchors I'd ever seen for use in the sand; the Lewmar Stainless Steel Horizon Claw in 2.2 lb. size.

It's pricey, but this gracefully curved and perfectly polished piece is pretty enough to display on your mantel during the off season!
http://www.marinewarehouse.net/image...ar/0058901.jpg

When we achored the 'yaks to a bar and got out to cast, there were no worries about them pulling loose and drifting away while we were concentrating on the fishing.

I was smitten with this anchor and will never be able to look my cheap, folding grapnel anchor straight in the eye again.... :rolleyes:

Good fishing,
desmobob

JonC 06-27-2010 10:47 AM

You can get a galvanized one really cheap, like $9, I use a slightly bigger one for my boat and I concur, it works great.
Jon

juro 06-27-2010 01:45 PM

Penguin gave me the demo as well. I'm going to get one for my Gloucester light dory once built in early July.

How is the release activated? Do you run a second line to the bend eye?

desmobob 06-27-2010 02:02 PM

Quote:

Originally Posted by juro
Penguin gave me the demo as well. I'm going to get one for my Gloucester light dory once built in early July.

How is the release activated? Do you run a second line to the bend eye?

I believe that's the design intention, although for use in sand it's not necessary. A pull from straight above will easily dislodge it.

You can get the not-nearly-so-pretty galvanized version from West Marine for $7.99! (Vs. $73 for the polished stainless steel version) http://www.westmarine.com/webapp/wcs...4&ci_sku=45443

Funny... on further research, it turns out Lewmar's Bruce "claw" design, although very popular, may be the least effective of anchor types.
http://www.rocna.com/main.php?sectio...testing&page=0

All I know is that I could not pull the little anchor through the sand (horizontal pull; lots of scope in the rode) and the thing is pretty. That has to count for something, right? :)

Good fishing,
desmobob

desmobob 07-18-2010 09:34 AM

Quote:

Originally Posted by juro

How is the release activated? Do you run a second line to the bend eye?

I just saw one guy's trick for using the rear pull for release. You attach your anchor rode at the eye at the bend (rear attachement point) and then lay it along the shaft of the anchor, securing it to the end eye with a zip tie.

If the anchor gets hung up, a strong pull from above will break the zip tie and then you'll (hopefully) be able to free it, now pulling from the rear eye.

I cheaped out and bought the "high tensile steel" $7.99 version. It's uglier than a plugged toilet. (Compared to the polished stainless steel version, anyway.)


Good fishing,
desmobob


All times are GMT -5. The time now is 03:27 AM.


Copyright Flyfishingforum.com (All Rights Reserved)