7/4- Monomoy Island, flats, fly, wade, saltwater, Chatham, Cape Cod, fis
Exaggerated tides have started. This normally brings in fresh fish. It will last until July 9. Look for fishing to be pretty good.
Walked a ½ mile out in knee-deep water in pea soup fog this A.M. using a compass to find the honey hole. It produced 5-6 fish in the 20-inch range. One fish that was lost had to be big as it bit the hook in half?
With increasing strong winds and storms forecast for mid-day we decided to just fish for ½ day. Hit several spots that had been producing on the same tides earlier this season. Today in these same spots it was slow. Looks like its mostly resident fish from here on out.
Fishing was slow for us today. Lil sun, in and out made it tuff to only sight fish. We positioned ourselves in an area where we could blind cast when there was no sun and sight fish when there was. It was an area where they transition in and out of the deeper water and also swim in and out of a cove.
Id like to thank AlanT for his crab pattern! My client's cast to several big fish on the flats today and landed a 40 incher (approx.25 lbs.) on his crab fly. He was most gracious to throw me one this A.M. at the dock at Outermost Harbor and Marina.
Noticed something for the first time this year on the flats. A good # of fish were not in a hurry on the flats. They would swim slower and hang around, grubbing for food. This is something you will normally see amongst the residents this time of year.
Moving slowly around and not wading out to far provided us with something not many people ever experience. Tailing Bass on the flats. You could see their tails flopping back and forth for balance.
A friend of mine saw, and landed a 30 incher under the same situation. A slow and stealth like approach is what is needed.
A dozen 20 lb'ers were sighted.
Congrats go out to Tom Brightman, first time flats fishing with a 25 lb. bass released!
Another very slow day. Worked transitional funnels on the flats while blind casting. Then to look for tailers. Worked several other feeding areas and came up empty. O-well. Today what we did was not called fishing, it was called tuff!
Decided to try someplace different than Monomoy today. With no sun we found fish in a foot of water cruising back and forth along a sand bar looking for a bite to eat. Very fussy, went through 20 different flies of all shapes and sizes. Finally lowered myself to throwing a white and chartreuse clouser. If I had had a kitchen sink I would have tried it. Good # of fish sighted w/ no sun! On the drop we decided to hit a flat that had a grass filled bowl next to it. They tend to hang a little longer on the flats if they have a safe exit. Good # of big fish sighted with the help of the afternoon sun and a couple caught. We walked one mile from the boat drop off and were exiled to an area void of boats and other anglers. How sweet it is!
Saw half dozen of those 20+lb'ers!
7/1 and 2
Sun made for some fabulous sight fishing on the flats! Lots of big fish spotted and cast to. Few keepers caught and released for future generations.
Fluorocarbon leaders vs Mono:
Fluorocarbon leaders have been getting a lot of attention in the last couple of years. The company tech reports usually claim that their line is superior to all others! With all of the different brands out there, I thought I'd give you my 2 cents.
I try to get away with as heavy a leader as the fish will let me so I can get the fish in a reasonable amount of time. Typically this means 8-12 lb. for the salmon, 4-8 lb. for the steelies and 8-20 lb. for Striped Bass and Blues. Bottom line is lighter leader=lower visibility leader=more strikes. Buyer beware though, there is some real CRAP fluorocarbon out there. About the best I've found is Orvis Mirage. It is low diameter, more flexible/durable than the others I've fished. Be sure to compare line diameters when buying any leader material, but especially with the Fluorocarbon. You'll see that the CRAP out there is quite a bit thicker than the good stuff. Some of the junk fluoro. will also delaminate as you fish it, not good.
This whole discussion really depends on what you're fishing for. From experience I can tell you that the steelhead have the best eyesight of all the trout and salmon. The lighter your leader the better . . . even better still if you fish fluorocarbon. Two big advantages to fishing fluoro. is that it is much more abrasion resistant than standard mono and because of it's reduced visibility you can often go a little heavier than you could with the mono. For example, fishing steelie's under normal water levels I usually fish 6-8 lb. leader. I can fish 8-10 lb. fluoro. with the same results. Yes, the Mirage fluoro. is very expensive, but I figure if it catches me a few more fish than it is worth every penny.
I have used several different kinds of Fluorocarbon leader material (Stren, Berkley,P-Line, International Angler, Bass Pro, Orvis). I feel that the Orvis Mirage or Orvis Mirage IGFA fluorocarbon is the best out there. It is quite abrasion resistant, has a low diameter to test ratio and disappears underwater. The downside is that it is expensive at $9.95/25 yards. However, I know it helps me to catch more fish, so it's worth the cost. I have been told that Yozuri and Triple Fish also make high quality fluorocarbon, but I have not had a chance to fish with it. Just remember something. The different brands that are rated at the same test will break over a wide range. The Orvis Mirage IGFA is guaranteed to break at the labeled test. If you compare that line in 8 lb. to Berkleys Vanish in 8 lb. you will find a big difference. The Berkley will break at as high as 12 lb. I have had guys complain that the Orvis breaks too easy. It breaks at what is labeled, and most lines out there over test by quite a bit.
Since Fluorocarbon does not absorb water such lines are both stronger and more durable than ordinary mono. 30% stronger in freshwater. 40% stronger in saltwater. Twice the shock resistance of nylon minimizes break-off at the strike. Reflects very little light - almost invisible in the water. The high density of fluorocarbon makes the line sink rapidly. Fluorocarbon Line is an ideal line for most fishing purposes!
We should all try to remember that we are stewards of our environment. If it were not for conservative minded people 20 years ago, we would not be enjoying the fruits of their labor today. Please remember that a fish is too valuable a resource to only be caught once. (Lee Wulff)
RE:7/4- Monomoy Island, flats, fly, wade, saltwater, Chatham, Cape Cod
A striper that bit through the hook?!! Now that's a BIG fish!
RE:7/4- Monomoy Island, flats, fly, wade, saltwater, Chatham.....
As "stewards of our environment" it seems there is one aspect of fluro leaders we ought to consider: the effect manufacture of this material has on the environment.
I certainly think it has to contribute to the overall mass of fluorocarbon emissions discharged per year, but I would be curious to know just what percentage it claims. I also know there are several types of fluorocarbons, some more damaging than others. Does anyone know the details of how leaders are made and if it contributes significantly to the problem of greenhouse gas levels??
This isn't meant as a criticism or an injunction against using fluorocarbon leader. It's just something that nags at me on a personal level. Any of you chemists out there have a take on this?
|All times are GMT -5. The time now is 11:10 AM.|
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright Flyfishingforum.com (All Rights Reserved)