Fly Fishing Forum - Reply to Topic
the Rod Rack Rod Builder's Forum

Thread: Method for removing epoxied reel seat butt cap? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
08-14-2003 12:45 PM
Robert Meiser Good on ya Tom.....

Tight lines...B. Meiser
08-14-2003 01:05 AM
Tom H. Thanks Bob, this method worked great!

It was an aluminum fly reel seat that wasn't mounted on a blank; thankfully, after my first attempt with boiling water:eyecrazy: Thanks for that heads up also Bob.

The very butt of the seat got a little marred from the levering but I think it will be mostly masked by the epoxying of the fitting butt.


Thanks again,
08-12-2003 08:23 PM
Robert Meiser Tom,

Assuming this is for the butt cap of a fly rod...And that the butt cap is either Nickel Silvler or Anodized aluminum...Not plastic.

You should be able to apply direct heat at the butt cap/ reel seat intersection with a butane cigarette lighter or alcohol lamp for a very few moments...Do not over do it, and rotate the butt as you heat.

This will oxidize the epoxy directly at this point and allow you to easily lever off the butt cap with a dull knife. It may take a couple of attempts.

If done carefully, you will not effect the rest of the reel seat /blank bond, nor harm the blank.

Boiling water can soften the whole epoxy bond at the reel seat to blank area...Or worse...Some blank resins will liquify at the boiling point of water, so caution should be taken when doing this.

Mail me if you wish.

Bob Meiser
08-12-2003 02:08 PM
Tom H.
Method for removing epoxied reel seat butt cap?

Can anyboddy recommend a method for removing an epoxied butt cap from a reel seat.

I tried putting the butt end of the seat in boiling water, but had no luck.

Any help would be greatly appreciated!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:27 PM.



Copyright Flyfishingforum.com (All Rights Reserved)