Fly Fishing Forum - Reply to Topic
the Rod Rack Rod Builder's Forum

Thread: Help Please Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
01-18-2008 06:22 PM
fishinfool
Thanks again

I really appreciate you guys taking the time to post your suggestions. I actually started working on it this afternoon and found that taking a plastic knife and rubbing over the area where the wraps had been worked much like you say the dowel rod did. I am about half way through removing the old wraps.
Best
John
01-18-2008 03:37 PM
flytyer I stumbled upon using a short piece of 1/8" - 1/4" dowel to remove the epoxy residue after the guide has been removed a few years ago. Simply rub the residue vigorously with the piece of dowel and it will come off. The rubbing with the dowel creates friction, which heats the epoxy just enough to soften it without harming the blank, and peels the epoxy residue off at the same time. Far safer than using a heat source and easy to do without worries about hurting the rod blank.
01-17-2008 03:08 PM
Warren Go to rodbuildingforum.com and ask that same question over there or at least do a search for that subject. There is some good info there from people who build & repair rods. Pete is on the right track but the guys over there say do not use tools to scrape off softened epoxy. Use your fingernail after you cut the wraps over the guides. that way you do not ruin the finish or worse cut through the fibers and weaken the rod
01-17-2008 07:53 AM
fishinfool Thanks for responding.
John
01-16-2008 01:03 PM
petevicar I assume that you have a normal carbon rod with the wraps sealed with epoxy. I have softened old wraps by heating them with a cigarette lighter but you must be very careful.
Then cut through as you suggest. The residue will normally come of with a sharp knife scraped along the blank but again be careful not to damage the blank.

Pete
01-16-2008 08:20 AM
fishinfool
Help Please

I have a rod that I want to re-finish over this winter. Could someone suggest the best approach to remove the old wraps on the guides, I am guessing just cutting through on top of the guide foot and then unwinding, and then what to use to get the residue of the coating off the blank?
Thanks in advance for your assistance.
John

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 12:27 AM.



Copyright Flyfishingforum.com (All Rights Reserved)