Fly Fishing Forum - Reply to Topic
>> Archive: Salmon & Steelhead Flies Spey flies to mixed wings, new innovations

Thread: Cut-to-length tubes for tube flies Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Home Waters
Your home waters
Current Favorite Fly
If you only had one... (change anytime)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
11-09-2006 03:33 PM
JimT Dwight,

I use a single edge razor blade to cut mine. To get a square end; I made a jig by drilling a hole in a piece of wood (needs to be a snug fit and square to the surface), slide the tube in the hole and use the wood block surface to slide the razor along and push through the tube. I then us a lighter or candle and twirl the end of the tube (free hand) close to the flame. A small burr forms in ID and I remove this with an Exacto knife. The whole process takes a few seconds. The key to a uniform, good looking flare, whatever method you use, is to get a square end.

Jim T
11-09-2006 03:31 PM
juro Lay the tube on a cutting surface (wood, cuttingboard etc)

Put the razor edge down on it.

Roll the tube sideways.

11-09-2006 01:43 PM
Charlie Dwight,

I use a razor blade to cut mine. And I use a nail or a pin to aide me when I am heating them up to form the flange on the end of the tube same as you. I usually do this on both ends of the tube. However, plastic tubes will usually not fray your tippet, especially the scandinavian stuff. It is fairly soft and will knot cut the leader. Hope this helps.

11-09-2006 12:50 PM
Cut-to-length tubes for tube flies

Hi there,

After just finishing some flies on the cut-to-length tubes I got to thinking about how they looked compared to some pictures I have as patterns (and I need to buy more tubes also, the sample packs I had are gone). After you cut an inch off the cut-to-length tube, I found my cuts were a little rough so I heated them with a cigarette lighter and formed them by shoving a finish nail up the tube to even out the cut and put a little flange on the end of the tube.

What have you found to be the best tool to cut the tube initially to reduce the roughness of the cut? What do you use to get that all round nicely formed flange on the end so the leader does not fray? Do you flange both ends? I was thinking maybe the nail was not the right idea, maybe another tool would be better..

Thanks alot, tubes are relatively new to me so I am still learning.


Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 10:46 PM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright (All Rights Reserved)