|05-15-2006 05:03 PM|
It is the third guide from the bottom, and at the middle joint. The rod is a 4 piece 5wt. I think I'll just move it up the rod 1/2' or what looks right and take it from there.
|05-15-2006 07:38 AM|
Guide close to ferrule
From your description it sounds like the guide foot ,assuming it is a snake, would be too close to the female ferrule. I would move it back to allow about 3/4-1" clearance of guide and wrap from female. There is a site <rodbuilding.org> where you could pose this question to get some other opinions on this.
I didnt ask before, what section of the rod are we talking about and what are the specifics of the rod, length,wt ,etc.,? In my opinion the further back on the rod the less critical is the issue of spacing.
|05-14-2006 11:07 PM|
|Night Raider||The centre of the guide is supposed to land 3/4" from the joint when the rod is tightly assembled. I figured that one would have to move, just how much.|
|05-14-2006 08:03 PM|
Guides close to ferrule
Nothing wrong with that, in fact I am pleased when I can locate a guide on the female ferrule. Less wrapping. Just make sure you have enough wrap on the ferrule before your thread climbs the guide foot, especially if it is a stripper.I like to have about the depth of the male ferrule wrapped on the female.Do you have complete engagement of the male end and the guide is 3/4" past that? You may want to give a little more space on the male end.
|05-14-2006 05:03 PM|
Guides close to ferrules
I'm laying out the guides on my first rod, a 4 piece 9'. With the spacing I'm using it has one guide with the centre 1" from the female end of a ferrule and another one 3/4" from the male part of a ferrule. I know it probably comes down to looks but I'd like some experienced opinions so I atleast know I'm headed in the right direction.