Fly Fishing Forum - Reply to Topic
Getting Started The only dumb question is the one not asked

Thread: Dissasembeling a rod? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
08-15-2005 11:55 AM
fcch The "behind the knees" always works for me. Remember NOT TO TWIST.

Twisting can splinter the blank in no time
08-15-2005 08:32 AM
teflon_jones Have you tried putting it behind your knees, grasping the two pieces, and then pushing apart with your knees (as opposed to pulling apart with your hands)?
08-14-2005 07:39 AM
juro Cool the ferrules down with ice. If you are near a cold river, just put the rod in the water for a while and try again. Works for me every time.
08-13-2005 07:33 PM
Smolt Put the rod back together, cast it five or ten times, then try again. This has worked for me. The flexing of the rod may loosen the ferrules that were stuck.
08-13-2005 07:33 AM
fishinfool
Try this

I have had good luck getting stuck sections apart by carefully grasping each section as close to the ferrule as possible while holding the rod behind my knees and then pushing out with the knees while gently twisting my hands. I don't know why this works but it seems to do the job. Good luck.
08-13-2005 07:28 AM
stjpball
Dissasembeling a rod?

I figured this is a basic question so id post it here im new to this forum...

Ok long story short i have a 3 piece Albright EXS, i was out for a day of smallmouth mouth fishing on one of the local river and i get to ym truck i pull apart the buttsection it come off easiy tbut then i try and pull apart the top 2 sections and they arent budgin a bit, ive used this rod about 15 times and ive ahd it for about 2 months its never happend befor with this rod or any other,

So is there any sort of tip anyone can give me to getting it apart. i dont wanna just yank on it and risk damaging the guides

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 11:38 AM.



Copyright Flyfishingforum.com (All Rights Reserved)