Fly Fishing Forum - Reply to Topic
the Rod Rack Rod Builder's Forum

Thread: changing a reel seat Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
02-04-2005 04:17 PM
andre Thanks, gives me a projrct for the late spring sounds like a plan...

andre
01-31-2005 06:31 PM
Nooksack Mac I've done this too. It helps to clamp the rod in a shop vise by its reel seat or lower grip; you don't have to worry about damaging them. Make a spiral cut with a hacksaw; I hope that neither end of the reel seat is buried under the upper handle. It helps to use two pliers to pull the sawed-through reel seat apart. Carefull; they're sharp.
01-31-2005 03:47 PM
Gary W Andre,

I would suggest hacksawing the reel seat in a spiral and then "peeling" it off. Some heat may be required to soften the bonding agent/glue.

Obviously, you would have to remove the bottom handle but, as the taper is relatively steady at this point on most blanks, a new one could be made, reamed and slid on from the bottom of the blank.

I have not tried this myself but did put the same question to a rod builder of considerable experience and that was the answer he gave to me. I'm thinking about doing the same to two rods that I own. One is a badly balanced single hander that I think would make an ideal switch/short spey rod(11ft). So I'll have to strip the whole handle and probably the stripper guide off it.

If I get round to it soon, I'll let you know how I get on.
01-26-2005 07:03 PM
andre
changing a reel seat

Hey guys I need some direction on swapping a reel seat on a Two Hander. The foot on the reel won't fit and the reel is worth more than the rod.

thanks

andre

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 09:36 AM.



Copyright Flyfishingforum.com (All Rights Reserved)