|09-28-2004 02:17 PM|
Thanks Sean, JD -
Unfortunately this is not conducive to "consistency" for lines with varying lengths over 80' like the ones I pointed out.
Therefore there is room for some further clarification in this area of the proposed standard in my opinion.
However the rest of the definition is nothing short of a Godsend.
|09-28-2004 01:49 PM|
What makes you think I am any better at mind reading than you?
I just know several of us have noticed the typo. I think Sean has a handle on it.
|09-28-2004 01:45 PM|
The way I understand it:
Long bellies are measured as any line over 70' with the grain measurement taken at 80' if they are over 80'.
|09-28-2004 01:19 PM|
In case it did not come thru in my post, "ecstatic" would be a proper word to describe how I feel about this standardization. Consistency is absolutely important, couldn't agree more.
I will drop Bruce Richards an email directly. Any excuse I can come up with to correspond with him is a good excuse, his insights into casting have been among the most influential to me in my study of flingin' a line. His analysis of casting and the way he describes it was like a revelation and has been a major influence to me. I highly recommend reading anything and everything he writes on the topic of casting.
However my point was to ask if anyone could clarify the definition of the extended belly lines, not to detract on it. Of course since the internet does not yet allow mind-reading, I should have said so specifically
So JD, you noticed the typo earlier. Until we master this mind-reading thing can you share what you found out about the long belly situation? (the point of my question)
|09-28-2004 01:09 PM|
And as to where the XLT & Grand Spey fit in, the important thing I think, is consistancy.
I applaud everyone who had even a minute part in bringing this about.
It may not be the perfect answer, but at least they are trying. And it is a big step in the right direction.
|09-28-2004 12:38 PM|
The listing mentioned long belly line head length to be 60-70 and a grain measurement to be 85'.
This is clearly a typo, but can I assume long belly means 75-85ft head? (split the difference theme of other ratings)
If so, where does this put the Grandspey and XLT?
Am I the only one to see this or did I miss something here?
|09-28-2004 11:52 AM|
Thank you Scientific Anglers for stepping up to the plate and all other parties involved. I like the "blind bowling" analogy.
|09-22-2004 11:03 PM|
Its a great step in the right direction.
No more blind bowling??? I hope.
|09-22-2004 09:30 PM|
I had hoped that the spey world would consider changing the basic line class
designations, either by adding a letter (such as "6S") or doubling the numbers
(suchas "66"). It is not clear at times now what a rod or a line is intended to
be. And as two-handed overhead casting takes root, this will become more difficult to discern.
|09-22-2004 03:35 PM|
What Do You Think Of the New Spey Line Standards?
Take a look at the article appearing at:
What do you think?