Fly Fishing Forum - Reply to Topic
the Rod Rack Rod Builder's Forum

Thread: Can't center cork grip turned on blank Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Home Waters
Your home waters
Current Favorite Fly
If you only had one... (change anytime)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
04-27-2006 06:37 AM
Gregory DeFoe
Off center cork grip

It sounds like the inletted bore of the cork ring was not concentric to the ring and/or the reel seat was not centered. When finished this would be the thinnest cork on the handle and minor errors could show up as you describe. While it is probably me, I do not fully understand your description of the method you used. If you would care to PM me with contact info perhaps I could talk you thru it. I build 2handers and turn all grips on the blank and have yet to have a problem like that.
Greg DeFoe
04-25-2006 11:10 PM
Can't center cork grip turned on blank

I glued-up my first grip ever on a blank and when I turned it in the drill lathe the seat hood showed through on one side. Obviously the grip became offcentered somehow. The reel seat is a REC with a round hood. I epoxied in a threaded REC fighting butt insert and then used a headless bolt threaded into the insert chucked into drill lathe. I did notice a little wobble that disappeared after a while. My thought was that the fighting butt insert or the reel seat itself was not centered. The difference between the width of the edge of the cork ring arround the hood is over 1mm. I would have noticed that difference if the reel seat was off by that much.
I then glued up another cork grip on another rod. Same model seat but without the fighting butt insert. I used the bushing made for the seat and it was centered perfectly on the blank. I bushed an old blank and inserted it into the butt end of the blank I was turning and it fit perfectly. Before I started I noticed that the cork ring over the hood was symmetrical at the aft end. When I started turning the grip the same thing happened. While I was careful not to exrose the hood like the former one, it still wanted to become offset. I sanded the high spot bringing the grip back to symmetrical. After I finished the grip is great but the ring over the hood is still offset.
To produce a straight stick of cork I epoxied 60 grit paper to a smooth board and applied it carefully to knock down the high spots. I use a Flex Coat lathe with 2 steadies.
I can't figure what I am I doing wrong.
Advise would be appreciated.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:34 PM.

vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright (All Rights Reserved)