Fly Fishing Forum - Reply to Topic
Lines, Loops and Leaders Line / Leader Recipes, Loops, Splices, etc.

Thread: A fundamental question of leader design Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Fly Fishing Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Home Waters
Your home waters
Current Favorite Fly
If you only had one... (change anytime)


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Additional Options
Miscellaneous Options
Rate Thread
If you like, you can add a score for this thread.

Topic Review (Newest First)
04-26-2004 09:11 AM
flyfisha1 I know what you mean about the smaller size of tippet spools. It's not a problem for me any longer, however, as I carry everything I need in a roomy fanny pack, so a couple of 300-yd. spools of line fit in easily. The other thing I've done is take spent tippet spools, as well as the little ones that cheap backing comes on, and re-load them with 20-yds. or so of line from a larger spool.
04-24-2004 08:27 PM
yes and no, mainly yes

I do the same thing that you do, and end up buying 300yds of p-line flourocarbon, and tie my own leaders with it. The little spools of tippet can be pretty handy out on the water though. Most people whom I've talked about this say that the leader spools in general are higher quality, but as long as the line you are using is of high quality, I think it makes no difference. While high quality flourocarbons and such may cost $7-$10, compared to those 30yd tippet spools your'e getting a tremendous value. Plus the large spools can easily last a season or two, unless you fish like me and change flies every 3 minutes. :hehe:
04-24-2004 11:45 AM
A fundamental question of leader design

Tapered leaders are quite pricey, leading many fly fisherman to start building their own. The trouble as I see it is that leader material is also pretty expensive for the puny length that comes on a spool. Because of this, I opted to buy bulk spools of mono and fluoro last year to make my leaders with, using the same material in each leader (not mixing mono and fluoro, though I think that when making leaders with double-nail knots it doesn't matter if you mix with regards to the slipperiness) and tying freshwater and saltwater leaders alike, all the way down to the tippet. The thing is, I never asked the question of others as to whether this was a wide-spread practice, particularly in freshwater trout fishing where tippet size is so thin. I've hooked and landed plenty of fish with these leaders (more with fluoro than mono), and never had a failure at a knot, so it's not an issue of landing fish, but perhaps more one of material softness that affects the number of fish that are interested in the fly at the end of the line.

So assuming that regular mono or fluoro can be purchased having the same approximate diameters as the much more expensive spools of tippet material, does it make more sense to
go this route? Comments?

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 09:17 PM.

Copyright (All Rights Reserved)